All shipping charges must be pre-paid. If the requested repairs or service including parts replacement are within the terms of this warranty, ADJ Products, LLC will pay return shipping charges only to a designated point within the United States. No accessories should be shipped with the product. If any accessories are shipped with the product, ADJ Products, LLC shall have no liability whatsoever for loss of or damage to any such accessories, nor for the safe return thereof.
This warranty is void if the serial number has been altered or removed; if the product is modified in any manner which ADJ Products, LLC concludes, after inspection, affects the reliability of the product; if the product has been repaired or serviced by anyone other than the ADJ Products, LLC factory unless prior written authorization was issued to purchaser by ADJ Products, LLC; if the product is damaged because not properly maintained as set forth in the instruction manual.
This is not a service contract, and this warranty does not include maintenance, cleaning or periodic check up. During the period specified above, ADJ Products, LLC will replace defective parts at its expense with new or refurbished parts, and will absorb all expenses for warranty service and repair labor by reason of defects in material or workmanship. All products covered by this warranty were manufactured after August 15, , and bear identifying marks to that effect.
Dual heaters - constant running. Medium size interior smoke machine. The little baby of the line up. Small V fogger for tight spaces, and those little smoke jobs. Small to Medium size budget v interior fogger Non Variable output. Real old School Outdoor Fogger. Run on Propane or MAP gas cartridge. Hand pump on fluid tank for. Hand tap on smoke out put line so you can control output volume unlike Green meanies. Smoke fluid same as PulsFog or Green Meanie. Robust and tough. Instruction Manual: Invented before stone tablets!
You need to be an experienced Props person! A member of the Rosco team will get back to you as soon as possible. Rosco Fog Fluid. Rosco Light Fog Fluid. Vapour Fog Machine. Intelligent Fog System. Request a quote Get your quote in 2 easy steps.
Thank you! Your quote request has been submitted. Address 2. Rinse the Fluid tank out with distilled water. Pour the cleaning solution into the fluid tank.
Take the fogger outside. Plug in the fogger and allow it to heat up. When the fogger is ready, run it until it stops. Try and avoid inhaling the vapor, I'm sure it's bad for you.
Repeat until you run out of solution or patience. I would estimate that 10 cycles should be enough. The output should start off as thick white smoke and slowly become a very thin haze over the many cycles. Unplug the fogger and rinse the fluid tank out with distilled water. Refill the tank with distilled water. About a half cup if you're going to use the fogger for fogging soon or about a half tank if you plan on storing the unit. Take the fogger outside again If you're not already there.
Plug the fogger in and allow it to heat up. Try and avoid inhaling the vapor , I'm sure it's bad for you. Repeat at least 5 times. You should do more cycles if it still smells like vinegar. You have to get all the vinegar out of the fogger. If you are planning to store the fogger, leave the distilled water in the tank. This will help keep the pump from siezing and keep the gaskets from shrinking. Please note, you have to store the fogger in it's normal operating position or the fluid may leak out.
Most machines have a small hole in the cap to allow air to enter during normal operation. When you are ready to use see below: If you are planning to use it soon in the next couple of weeks. Empty any remaining water from the fluid tank and refill with fog fluid. The best time to clean a fogger if you plan to store it is after you use it it doesn't have to be immediatly after you use it, but within a day or so.
If you use your fogger on a regular basis, I have found that monthly cleanings will greatly increase it's life. I maintain an attraction where 2 small foggers are used constantly and if I do regular maintenance I can get over a year out of a fogger, whereas if I don't we've replaced them in less than 8 months.
You can shoot fog through a hose to get fog into tight places you can't get the machine into. A Dryer vent hose works best, it is about 4" in diameter and cheap. You don't need the fancy metal ones, the basic white plastic ones work and you can spray paint them to match the surrounding area.
The one big thing to remember is not to seal the hose to the machine. When Fog exits the machine it needs to mix with air otherwise it quickly becomes liquid again and will drip out of the hose.
Leave at least a 1" air gap between the hose and machine. I have left up to a 4" gap and still managed to get the fog to all go through the tube.
0コメント