If a drive occupies an IDE channel by itself some computers can have more than one IDE channel , it should be set up as an only drive. If there are two drives on an IDE channel, one must be set as master, the other as slave. Only the master can be the boot disk. You must tell the computer that a new hard drive has been added.
In most cases, as the computer boots, it will prompt you to press a certain key or key combination to get into the CMOS. Upon starting the computer, press the appropriate key when prompted to enter the CMOS setup program. All of them have a screen where you can set drive parameters. Most current CMOS setup programs can auto-detect the hard drive's geometry, so you usually will not have to input the drive parameters cylinders, heads, and sectors.
If you are installing a drive larger than MB, make sure that LBA or Large mode is turned on before you do the auto-detect. You may not have to set this option on newer computers. However, if you have an older motherboard that does not support LBA mode, you may not be able to use all of the space on the drive. After entering the necessary information or allowing auto-detect, exit the CMOS setup and allow the computer to boot from the old hard drive which is set as master.
Remember, since modern applications and operating systems consist of a large number of small files, a large minimum cluster size can waste a significant amount of hard drive space. Another thing to note is the maximum limit of the partition sizes with either file system. FAT32 extends this limit to 4 terabytes.
In addition, the Extended DOS partition may be further subdivided into several virtual drives. Decide how many virtual drives you wish to make on the new hard drive. If you have a 2. Then, make two virtual drives on the Extended partition, the first being MB and the second the remainder of the space about MB. Following these instructions incorrectly could result in the loss of data or cause your computer to malfunction. FAT32 is primarily designed for Windows 98 and some versions of Windows Note: If you enable large disk support and create any new drives on this disk, you will not be able to access the new drives using other operating systems, including some versions of Windows 95 and Windows NT, as well as MS-DOS.
In addition, disk utilities that were not designed explicitly for the FAT32 file system will not be able to work with this disk. If you need to access this disk with other operating systems or older disk utilities, do not enable large disk support. Follow the steps below to run Fdisk on systems with hard drives larger than 2. Known problems occur in many Packard Bell models as well as many older computer models. Follow steps 1 to 11 Follow steps 12 to Most Popular.
The Benefits Of Online Shopping. Effect of Data Loss. Eliminating Home Theater Hum and Noise. Advantages Of CRM. Types of Computer Hardware. Identity Theft and Social Networking Sites. Iphone Product Description.
Top Searches on. Singapore Jobs. Comparison of CD Printing Processes. Point Of Sale Systems. Recordable DVD formats explained. Hiring Tips - Computer Consulting. Elucidation To Recover Computer Data.
Mini DV Decks. Document Scanning and Management Systems : a Review. Writing yourself Into a Story. The Importance of Windows Updates.
0コメント